Prior to Install

  1. Power off your device and/or remove battery.
  2. Clean your hands thoroughly to remove oils/dirt/or debris.
  3. Identify each piece of the Ghost Armor film and visually align them with the device.
  4. Take a coffee cup or small bowl, fill with warm water and add 6 drops of everyday dish washing soap. Make sure to fill with warm water first before adding soap. This will help avoid making soapy bubbles. Ensure that the cup is completely washed out before making the solution.
  5. Use your finger to stir the soap and water together to mix the solution completely. Try to avoid making soapy bubbles. Clean your device thoroughly with the cleaning cloth that has been damped with soapy water, to insure that your phone is clean of any residue (i.e. dust, dirt or facial oils).
  6. Take your ID/credit card/or any similar plastic card, and wrap it in your cleaning cloth to make a squeegee.

Installation Instructions:

  1. Wet your fingers prior to removing the film from the backing paper. Keep your fingers wet during the entire application to avoid leaving finger prints on the adhesive side. (Begin with larger pieces, i.e. screen & back)
  2. Peel off the piece that you choose to apply first and completely immerse it in the cup of soapy water for 10-20 seconds. Let the excess drip of. Try not to make soapy bubbles.
  3. Do not allow the film to touch anything before applying it to your device, or the dirt will stick to the adhesive. Apply the Ghost Armor film to your device, sticky side down.
  4. After aligning Ghost Armor Film, firmly hold the Ghost Armor film in place, then, use the ID/credit card wrapped with the cleaning cloth to smooth the film. Start from the middle, push outward toward the outer edges. It may be necessary to do this step several times, applying more pressure each time, to squeeze out bubbles.
  5. If there is any portion of the Ghost Armor film that does not stick to the device, allow the film to dry completely and then apply pressure to the portion that did not stick to the device, eliminating all bubbles until this portion of the film adheres to the device. Allow the device to sit with any tabs extended until the sticky side is dry. Once it has dried, wrap each tab, one at a time, around the device. Make sure that one tab is securely down, without any bubbles, prior to securing the next tab.